Armeg 10mm x 400mm Cable Guide Drill Bit
The best ideas are the simplest and the Armeg Cable Guide Drill Bit is a simple but very effective product. Users can drill a cavity wall in the normal way, connect the cable and pull it through the cavity. A brilliant time and money saving innovation and typical of the innovative products available in the Armeg drilling & tool ranges.
The One Tool Solution to cable guiding. One of Armeg's latest innovations! No Rods - No Wires - No Tape - No Magnets. Why buy several tools when you can use just one.
Based around a 10mm x 400mm High quality SDS Drill bit. Simply drill through the wall in the required place, bare a short length of wire at the end of the cable to be pulled. Thread through the specially designed hole in the end of the drill bit or detach the SDS machine and thread through the hole in the shank end and pull the cable through.
Especially useful when there is rubble or insulation material present in the cavity as the drill bit is left in place whilst the cable is attached.
Features & Benefits:
• Specially designed hole in each end of the bit
Routing of Cables, i.e. Electrical, TV, Satellite, Telephone, Alarm, Data, Speaker etc
Do you have a bulk order?
If you have a bulk order for this item then we may be able to offer you an extra discount. Please call our order line on 0208 805 3535 for a quote.
Please note : to qualify for a bulk discount where not already specified on the website, a bulk order would be considered to be normally a minimum of around 100 units for lower value items, and sometimes less if it is high value item.