Hozelock 2 In 1 Submersible Flood & Dirty Water Pump with Float Switch 6 Metre Lift 6000 Litres Hour Max Flow 240v

Was £57.95
Offer Price
£53.95 inc VAT
 

QL146270

  • Our Part Number HOZ7825
Email this page Printable version  

Details

Hozelock 2 In 1 Submersible Flood & Dirty Water Pump with Float Switch 6 Metre Lift 6000 Litres Hour Max Flow 240v

Hozelock's Flood Pump will move water quickly and efficiently. Flood Pump can be left set-up and will operate automatically when the water level rises. Pump turns on at 400mm water depth, and switches off at 190mm water depth. Use Flood Pump in the house or in the garden. For use in cellars, garages, with garden flooding, and in trenches and ditches.

High flor pump maximum flow 6000 litres per hour and maximum lift 6m. The flood pump is a self priming pump that can pump dirty and clean water to enable the emptying of flooded rooms, cellars, and ditches. In areas that are prone to flooding the pump can be left set up and the automatic float switch will turn the pump on as the water level rises. The pump works best when it is installed in a sump.
The pump can also be used to move clean and dirty water around the garden, eg to transfer the water from a padding pool to a water butt.

This pump is not suitable to be used in swimming pools, table fountains, aquariums, fountains, filters for fish ponds, waterfalls

Includes:
Automatic on/off water level sensor
1 x Stepped hose adaptor (25mm to 32mm)
1 x Multi use Flood Pump
10m cable and plug

Additional information regarding Submersible Water Pumps
Clean Water Pumps:
Generally clean water pumps are suitable for the drainage of cellars, sinks, cisterns, pools, baths and other general transfer of water. They are not suitable for outside ponds or other dirty water as they will only usually allow small particles to pass through. Most clean water pumps will allow suction to a very low level (normally within 5 - 10mm) before they cut out but remember this only applies if they have a float switch.

Dirty Water Pumps:
These are suitable for the drainage of most water types as they allow for a much larger particle types. Be aware however that they will usually drain water down to a level of between 25 - 50mm depending on the particle size that they allow for. Automatic cut out only applies if they have a float switch. Unless specified dirty water pumps are not suitable for agriculture type use or for drainage of water containing salt or other chemicals. The term 'dirty' in most cases applies to 'water contains small particles such as grit, sand, mud and small pebbles'.

Considerations when buying a Submersible or Surface water pump:

1. Particles over 1mm generally, can only pass through dirty water pumps. Always buy a pump that will allow the particle size that you require to flow through it.

2. Float switches enable the pump to cut-out when the water reaches the minimum level at which the pump can operate without overheating. Clean water pumps can operate at a lower level than dirty water pumps as they do not have to account for particles being able to pass through the bottom of the pump. Pumps without a float or auto cut out type switch cannot run automatically and have to manually be controlled.

3. Water pumps have differing flow rates so ensure you purchase a pump capable of transferring water at your desired speed; this is normally calculated as litres per second or litres per hour.

4. The distance or height that a water pump is capable of moving water is known as the lift height use the following calculation to determine if the pump is suitable for your requirements:

The maximum flow rate of a pump is directly affected by the height it has to lift the water. In general the flow rate will decrease as the lift height increases. Horizontal pumping distance is also affected use the formula Max Height - Working Height x 10 to determine the maximum horizontal distance the pump will be capable of.

It is recommended that an RCD is always used with a submersible pump as should be the case whenever electrical products are used near water.

Important:
Most submersible pumps require a lay flay hose (except water butt pumps) which have a wider diameter than garden hose in order to drain the water without damaging the pump, to allow for particles (if applicable) and to allow for fast flow rates.

Specifications

Mfr Part Number7825P8000
Our Part NumberHOZ7825
ManufacturerHozelock
Flow Rate100 l/min
Lift Height6m
Model No7825P8000
Output Aperture (mm)32mm
Cable Length (m)10m
Float SwitchYes
Clean or Dirty WaterDirty
Power240v Electric
Wattage250w
Item Weight5kg

Reviews

Sort by

Showing 1 to 2 of 2 reviews

Most Recent Customer Reviews for Hozelock 2 In 1 Submersible Flood & Dirty Water Pump with Float Switch 6 Metre Lift 6000 Litres Hour Max Flow 240v

John shine | 26 June 2013

Overall RatingOverall Rating 5 TsOverall Rating 5 TsOverall Rating 5 TsOverall Rating 5 TsOverall Rating 5 Ts
Value for MoneyValue Rating 5 TsValue Rating 5 TsValue Rating 5 TsValue Rating 5 TsValue Rating 5 Ts
FeaturesFeatures Rating 5 TsFeatures Rating 5 TsFeatures Rating 5 TsFeatures Rating 5 TsFeatures Rating 5 Ts
PerformancePerformance Rating 5 TsPerformance Rating 5 TsPerformance Rating 5 TsPerformance Rating 5 TsPerformance Rating 5 Ts
ReliabilityReliability Rating 5 TsReliability Rating 5 TsReliability Rating 5 TsReliability Rating 5 TsReliability Rating 5 Ts
Build QualityBuild Quality Rating 5 TsBuild Quality Rating 5 TsBuild Quality Rating 5 TsBuild Quality Rating 5 TsBuild Quality Rating 5 Ts

This hozelock pump simply meets "ronson" product strict requirements : "it does exactly what it says on the tin". if you experience the odd "flooding " problems and poor weather conditions (heavy rain) are forecast, set up the pump with the other end of the hose connected to a drain, plug the pump into a live socket and leave it to turn itself on and off as appropriate. fantastic!!

Was this review helpful to you? Yes | No

John shine | 14 May 2013

Overall RatingOverall Rating 5 TsOverall Rating 5 TsOverall Rating 5 TsOverall Rating 5 TsOverall Rating 5 Ts
Value for MoneyValue Rating 5 TsValue Rating 5 TsValue Rating 5 TsValue Rating 5 TsValue Rating 5 Ts
FeaturesFeatures Rating 5 TsFeatures Rating 5 TsFeatures Rating 5 TsFeatures Rating 5 TsFeatures Rating 5 Ts
PerformancePerformance Rating 5 TsPerformance Rating 5 TsPerformance Rating 5 TsPerformance Rating 5 TsPerformance Rating 5 Ts
ReliabilityReliability Rating 5 TsReliability Rating 5 TsReliability Rating 5 TsReliability Rating 5 TsReliability Rating 5 Ts
Build QualityBuild Quality Rating 5 TsBuild Quality Rating 5 TsBuild Quality Rating 5 TsBuild Quality Rating 5 TsBuild Quality Rating 5 Ts

This pump was one of very few available that i could find which enabled use by simply setting up, plugging in and leaving in case there was a flood when it would turn itself on then off automatically. magic! prior to this, the pump i was using needed to be turned on and off manually every two hours or so for nearly three days. My eyes looked like "you know what" in the snow! fantastic product - just love it!

Was this review helpful to you? Yes | No

Sort by

Showing 1 to 2 of 2 reviews


Available downloads for this product

Get Adobe ReaderYou may need Adobe Reader to view some of our downloads. If you do not already have it installed please click the icon to the left to install it

More Help

More Help with this product...

If you require more information or assistance with this product please consult the links below :

Bulk Prices

Do you have a bulk order?

If you have a bulk order for this item then we may be able to offer you an extra discount. Please call our order line on 0208 805 3535 for a quote.

Please note : to qualify for a bulk discount where not already specified on the website, a bulk order would be considered to be normally a minimum of around 100 units for lower value items, and sometimes less if it is high value item.

 

Tooled-Up.com