Draper Stainless Steel Submersible Dirty Water Pump with Float Switch 8 Metre Lift 12500 Litres Hour Max Flow 750w 240v

Was £84.95
Our Price
£74.95 inc VAT
 

QL199793

  • Our Part Number 25360
Email this page Printable version  

Details

Draper Stainless Steel Submersible Dirty Water Pump with Float Switch 8 Metre Lift 12500 Litres Hour Max Flow 750w 240v

For pumping out inspection pits, ditches and footings where solids may be present; general irrigation and other heavy duty applications. Ideal for irrigating gardens, draining cellars/basements. Float switch automatically cuts pump off when water has dropped to the required level. Supplied with stepped hose adaptor, 10M (approx.) cable and approved plug.

Specification:
Maximum head height   ...   8.0M
Maximum output   ...   208L/min
Maximum water temperature   ...   35°C
Maximum particle size   ...   35mm dia.
Output aperture   ...   32mm dia.

Additional information regarding Submersible Water Pumps
Clean Water Pumps:
Generally clean water pumps are suitable for the drainage of cellars, sinks, cisterns, pools, baths and other general transfer of water. They are not suitable for outside ponds or other dirty water as they will only usually allow small particles to pass through. Most clean water pumps will allow suction to a very low level (normally within 5 - 10mm) before they cut out but remember this only applies if they have a float switch.

Dirty Water Pumps:
These are suitable for the drainage of most water types as they allow for a much larger particle types. Be aware however that they will usually drain water down to a level of between 25 - 50mm depending on the particle size that they allow for. Automatic cut out only applies if they have a float switch. Unless specified dirty water pumps are not suitable for agriculture type use or for drainage of water containing salt or other chemicals. The term 'dirty' in most cases applies to 'water contains small particles such as grit, sand, mud and small pebbles'.

Considerations when buying a Submersible or Surface water pump:

1. Particles over 1mm generally, can only pass through dirty water pumps. Always buy a pump that will allow the particle size that you require to flow through it.

2. Float switches enable the pump to cut-out when the water reaches the minimum level at which the pump can operate without overheating. Clean water pumps can operate at a lower level than dirty water pumps as they do not have to account for particles being able to pass through the bottom of the pump. Pumps without a float or auto cut out type switch cannot run automatically and have to manually be controlled.

3. Water pumps have differing flow rates so ensure you purchase a pump capable of transferring water at your desired speed; this is normally calculated as litres per second or litres per hour.

4. The distance or height that a water pump is capable of moving water is known as the lift height use the following calculation to determine if the pump is suitable for your requirements:

The maximum flow rate of a pump is directly affected by the height it has to lift the water. In general the flow rate will decrease as the lift height increases. Horizontal pumping distance is also affected use the formula Max Height - Working Height x 10 to determine the maximum horizontal distance the pump will be capable of.

It is recommended that an RCD is always used with a submersible pump as should be the case whenever electrical products are used near water.

Important:
Most submersible pumps require a lay flay hose (except water butt pumps) which have a wider diameter than garden hose in order to drain the water without damaging the pump, to allow for particles (if applicable) and to allow for fast flow rates.

Specifications

Mfr Part NumberSWP210DWSS
Our Part Number25360
Model NoSWP210DWSS
ManufacturerDraper
Power240v Electric

Reviews

Most Recent Customer Reviews

Stephen spencelayh | 30 May 2014

Overall RatingOverall Rating 4.5 TsOverall Rating 4.5 TsOverall Rating 4.5 TsOverall Rating 4.5 TsOverall Rating 4.5 Ts
Value for MoneyValue Rating 4.5 TsValue Rating 4.5 TsValue Rating 4.5 TsValue Rating 4.5 TsValue Rating 4.5 Ts
FeaturesFeatures Rating 4.5 TsFeatures Rating 4.5 TsFeatures Rating 4.5 TsFeatures Rating 4.5 TsFeatures Rating 4.5 Ts
PerformancePerformance Rating 4.5 TsPerformance Rating 4.5 TsPerformance Rating 4.5 TsPerformance Rating 4.5 TsPerformance Rating 4.5 Ts
ReliabilityReliability Rating 4.5 TsReliability Rating 4.5 TsReliability Rating 4.5 TsReliability Rating 4.5 TsReliability Rating 4.5 Ts
Build QualityBuild Quality Rating 4.5 TsBuild Quality Rating 4.5 TsBuild Quality Rating 4.5 TsBuild Quality Rating 4.5 TsBuild Quality Rating 4.5 Ts

This pump was bought to replace another draper pump which finally died after extensive use pumping water from my garden for a number of years. I decided to buy a stainless steel version as i hope it will be more robust than the plastic bodied versions. I rationalised the higher price by selecting a pump with slightly less throughput. It works very effectively and i hope to have many more years of use from it.


More Help

More Help with this product...

If you require more information or assistance with this product please consult the links below :

Bulk Prices

Do you have a bulk order?

If you have a bulk order for this item then we may be able to offer you an extra discount. Please call our order line on 0208 805 3535 for a quote.

Please note : to qualify for a bulk discount where not already specified on the website, a bulk order would be considered to be normally a minimum of around 100 units for lower value items, and sometimes less if it is high value item.

 

Tooled-Up.com