Metabo TBP 4000M Deep Well & Bore Hole Water Pump 55m Lift 3800L Hour Max Flow 750w 240v

Our Price
£281.95 inc VAT


  • Our Part Number M0250400055
Email this page Printable version  


Metabo TBP 4000M Deep Well & Bore Hole Water Pump 55m Lift 3800L Hour Max Flow 750w 240v

Deep well / Bore hole pumps suitable for great depths. With an integrated check valve so water cannot flow back into the pump.

- Especially suitable for great depths, such as bore wells and shafts
- 22 m connection cable for more submerged depth
- 7-level pump running gear for a delivery height of max. 55 m = 5.5 bar pressure
- Solid pump head with brass thread insert and fixing eyelets for the drain rope (1 pump outlet)
- Integrated check valve: the water in the hose cannot flow back to the pump
- Suitable for bore wells of 100 mm Ø (4")
- Pump housing made of special steel and impact-resistant plastic

Rated input power: 750 W
Maximum delivery rate: 3800 l/h
Maximum delivery height: 55 m
Maximum submerged depth: 20 m
Maximum pressure: 5,5 bar
Discharge port: 1"
Pump housing: Special steel/ plastic
Pump diameter: 98 mm
Power cable: 22 m
Number of roller wheels: 7
Weight: 12 kg

Additional information regarding Submersible Water Pumps

Clean Water Pumps:
Generally clean water pumps are suitable for the drainage of cellars, sinks, cisterns, pools, baths and other general transfer of water. They are not suitable for outside ponds or other dirty water as they will only usually allow small particles to pass through. Most clean water pumps will allow suction to a very low level (normally within 5 - 10mm) before they cut out but remember this only applies if they have a float switch.

Dirty Water Pumps:
These are suitable for the drainage of most water types as they allow for a much larger particle types. Be aware however that they will usually drain water down to a level of between 25 - 50mm depending on the particle size that they allow for. Automatic cut out only applies if they have a float switch. Unless specified dirty water pumps are not suitable for agriculture type use or for drainage of water containing salt or other chemicals. The term 'dirty' in most cases applies to 'water contains small particles such as grit, sand, mud and small pebbles'.

Considerations when buying a Submersible or Surface water pump:

1. Particles over 1mm generally, can only pass through dirty water pumps. Always buy a pump that will allow the particle size that you require to flow through it.

2. Float switches enable the pump to cut-out when the water reaches the minimum level at which the pump can operate without overheating. Clean water pumps can operate at a lower level than dirty water pumps as they do not have to account for particles being able to pass through the bottom of the pump. Pumps without a float or auto cut out type switch cannot run automatically and have to manually be controlled.

3. Water pumps have differing flow rates so ensure you purchase a pump capable of transferring water at your desired speed; this is normally calculated as litres per second or litres per hour.

4. The distance or height that a water pump is capable of moving water is known as the lift height use the following calculation to determine if the pump is suitable for your requirements:

The maximum flow rate of a pump is directly affected by the height it has to lift the water. In general the flow rate will decrease as the lift height increases. Horizontal pumping distance is also affected use the formula Max Height - Working Height x 10 to determine the maximum horizontal distance the pump will be capable of.

It is recommended that an RCD is always used with a submersible pump as should be the case whenever electrical products are used near water.

Most submersible pumps require a lay flay hose (except water butt pumps) which have a wider diameter than garden hose in order to drain the water without damaging the pump, to allow for particles (if applicable) and to allow for fast flow rates.


Mfr Part NumberTBP 4000M
Our Part NumberM0250400055
Power240v Electric
Shipping Weight12kg
Cable Length (m)22m
Float SwitchNo
Flow Rate63 l/min
Lift Height55m
Model NoTBP 4000M
Output Aperture (mm)25mm
Item Weight12kg
Clean or Dirty WaterClean


Sort by

Showing 1 to 0 of 0 reviews

Most Recent Customer Reviews for Metabo TBP 4000M Deep Well & Bore Hole Water Pump 55m Lift 3800L Hour Max Flow 750w 240v

This product is yet to be reviewed. Be the first to leave a review.

Videos & Downloads

Available videos for this product

Metabo Corporate Video

Metabo Quality Control Video

Available downloads for this product

Get Adobe ReaderYou may need Adobe Reader to view some of our downloads. If you do not already have it installed please click the icon to the left to install it

More Help

More Help with this product...

If you require more information or assistance with this product please consult the links below :

Bulk Prices

Do you have a bulk order?

If you have a bulk order for this item then we may be able to offer you an extra discount. Please call our order line on 0208 805 3535 for a quote.

Please note : to qualify for a bulk discount where not already specified on the website, a bulk order would be considered to be normally a minimum of around 100 units for lower value items, and sometimes less if it is high value item.