Sealey Locking Nuts
Loading...
End of content
Error - No more pages to load
Sealey Locking Nuts at Tooled-Up.com
Sealey Locking Nuts are replacement fixings for angle grinder backing pads and quick-change grinder systems. Tooled-Up.com stocks thread-specific options, including the Sealey M10 x 1.25mm and M10 x 1.5mm nuts for the PTC/BP3 90mm backing pad, the M14 x 2mm nut for the PTC/BP4 104mm backing pad, the M14 Pad Nut for 170mm backing pads and the M14 Quick Change Angle Grinder Locking Nut.
Each nut is made to fit a particular pad or grinder spindle, so you can restore a worn or lost fixing without replacing the whole backing pad assembly.
Key Features of Sealey Locking Nuts
- Thread-specific sizing: M10 x 1.25mm, M10 x 1.5mm, M14 and M14 x 2mm options match the pad or spindle, so the nut seats correctly and holds firm.
- Backing pad compatibility: Nuts for the PTC/BP3 (90mm) and PTC/BP4 (104mm) pads, plus a 170mm pad nut, let you keep existing pads in service.
- Precision-threaded design: A clean thread engages smoothly and secures the pad during polishing and sanding, reducing slippage and wobble.
- Quick-change option: The M14 Quick Change Locking Nut allows faster disc swaps on an angle grinder, so less time is lost between grits or accessories.
- Replacement spare part: A low-cost way to keep a pad assembly working when the original nut is damaged, cross-threaded or misplaced.
Who Uses Sealey Locking Nuts?
These nuts suit anyone running backing pads on an angle grinder. Vehicle bodyshop technicians and valeters use them for sanding and polishing, while fabricators and welders rely on them for metalworking and surface preparation. Maintenance engineers and keen DIYers also keep spares handy for general grinding, rust removal and finishing jobs on site or in the workshop.
Browse the Sealey selection at Tooled-Up and match the nut to your pad size and thread before ordering.
Frequently Asked Questions
How do I choose the right Sealey locking nut?
Check the thread size on your grinder spindle or backing pad (for example M10 x 1.25mm, M10 x 1.5mm or M14) and the pad diameter. Then choose the nut made for that pad, such as the PTC/BP3 90mm or PTC/BP4 104mm.
Can I use an M10 x 1.25mm nut in place of an M10 x 1.5mm nut?
No. The thread pitch differs, so the nut will not seat properly and could damage the thread. Always match the exact pitch.
What is a quick change locking nut for?
The Sealey M14 Quick Change Angle Grinder Locking Nut lets you swap discs and pads faster than a conventional nut, which suits jobs that need frequent accessory changes. Shop Sealey Locking Nuts at Tooled-Up.com to find the right fit.
