Trend RBT/1 Routabout Jig for 18mm Floors

The Trend RBT/1 Routabout Jig is a specialist routing template designed to cut clean 250mm diameter access holes in 18mm chipboard floors, allowing tradespeople to reach pipes and cables beneath with minimal disruption.

Ideal for builders, plumbers, and electricians working in both new-build and existing properties, the jig guides a plunge router to cut precisely through the floor board — and no further. Because the cut piece is retained and reused to make good the opening, there is no waste and no need for separate repair materials.

The system requires a plunge router of 750 watts or above to operate. A Unibase adaptor may be required depending on the make and model of router being used. Everything else needed for the job is included in the kit.

Features and Benefits:
• Cuts a 250mm diameter opening through 18mm chipboard or similar flooring
• Cuts only the board thickness — no risk of damaging pipes or cables below
• Zero waste — the cut-out is used to reinstate the floor after access
• Supplied with three spacer rings to accommodate different installation requirements
• Includes a TCT router cutter and 30mm guide bush — no additional tooling required
• Suitable for new and existing chipboard floors

Specifications:
Shank Diameter: 1/4"
Cut Length: 18mm

Contents:
1 x Routabout template
3 x Spacer rings
1 x Special TCT router cutter
1 x 30mm Plastic guide bush