DeWalt DMF1550 Manual Flooring Nailer

The DeWalt DMF1550 is a manual flooring nailer designed for the precise and efficient installation of tongue-and-groove hardwood and engineered flooring on professional job sites.

Powered entirely by manual operation, this cleated nailer requires no air compressor or power source, making it straightforward to deploy across a range of site conditions. The ratchet drive mechanism is a standout feature, allowing the operator to strike the driver head multiple times until the cleat is fully set — particularly useful when working with denser timber or tighter board fits. This mode can also be disengaged for standard single-blow operation, giving the flooring contractor full control over the driving process.

Protecting expensive flooring during installation is essential, and the DMF1550 addresses this directly with rubber bumpers positioned at both the side and front of the tool. These absorb impact and prevent surface marking, helping to maintain the quality of the finished floor. With a magazine capacity of 120 nails and a fastener range of 38–50mm, it suits a variety of flooring thicknesses and installation requirements.

Features and Benefits:
• Ratchet drive mode allows multiple strikes to fully set the cleat — can be disengaged for single-blow operation
• Rubber bumpers on the side and front of the tool protect finished flooring from damage during nailing
• High-capacity 120-nail magazine reduces the frequency of reloading on site
• Manual power source — no air compressor or electricity required

Specifications:
Magazine Capacity: 120 Nails
Fastener Range: 38–50mm
Length: 340mm
Width: 89mm
Height: 444mm
Weight: 3.9kg
Power Source: Manual